** This Ad is Marked as SOLD by seller and cannot be responded to. **
Dismantling my system for an upcoming move - offered here is my McIntosh MC162 Amplifier in perfect operating condition and very good cosmetic condition.
I purchased the amp about two months ago from a dealer and had the unit fully checked out and new bulbs installed - functionally, it's like a brand new amp with no issues whatsoever. Cosmetically, it was rated 9/10 when I bought it, and remains in the same condition. The only cosmetic blem I can find is a black line (looks like sharpie) that is about three quarters of an inch long on the top, which is only visible up close and under careful inspection. Glass is perfect, bulbs are bright and strong with less than 100 hours on them. The amp looks fantastic.
The amp has the wonderful McIntosh house sound - powerful, detailed, and so very musical. I replaced the stock fuse with an AMR Gold Fuse to wonderful effect - reduced some glare and further improved an already wonderful midrange. Two 160 watt high current output channels - staggering 500 watts bridged - will drive and speaker with authority. The MC162 reproduction is sonically transparent and absolutely accurate.
The amp will ship in the original McIntosh boxes for safe arrival.
Buyer to pick up shipping via FedEx or UPS (your preference); please add 3% for paypal.
Power Output Per Channel 160 watts into 4 or 100 watts into 8 ohm loads is the minimum sine wave continuous average power output per channel both channels operating.
Power Output Bridged 500 watts into 4 ohms or 320 watts into 8 ohm loads is the minimum sine wave continuous average power output.
Output Load Impedance 4 or 8 ohms
Rated Power Band 20Hz to 20,000Hz
Dynamic Headroom 1.6dB
Frequency Response +0, -0.25dB from 20Hz to 20,000Hz +0, -3dB from 10Hz to 100,000Hz
Total Harmonic Distortion 0.005% maximum at any power level from 250 milliwatts to rated power per channel from 20Hz to 20,000Hz, both channels operating.
Intermodulation Distortion 0.005% maximum if instantaneous peak output per channel does not exceed twice the rated output with both channels operating for any combination of frequencies from 20Hz to 20,000Hz.
Signal To Noise Ratio 110dB below rated output
Sensitivity .9 volts (2.0V at level control center detent position)
Damping Factor Greater than 100 at 4 ohms Greater than 200 at 8 ohms
Dimensions Front Panel: 17/1/2 inches (44.5cm) wide, 5-3/8 inches (13.7cm) high. Depth behind front mounting panel is 18 1/2 inches (47cm) including clearance for connectors. Panel clearance required in front of mounting panel is 1-1/8 inches (2.9cm).
Weight 42 pounds (19.1 Kg) net, 60 pounds (27.2 Kg) in shipping carton
Original box, power cord.
Calculate Estimated Shipping Cost
This feature is only available for logged in members. Please login or register here.