Description �@ The floor type speaker system which combined the latest acoustical engineering with the enclosure of column form, and realized a wide-range flat response and extensive directional characteristics.
The 30cm cone type Woofer by an IMG cone is carried in low-pass. This IMG cone is a cone which consisted of composite materials of a graphite fiber and polypropylene, and is fabricated under loud sound and a high voltage (injection molding: Injection Molding). The graphite fiber is radiately arranged toward the perimeter from the hub, and its undeformed operation area of a cone is large, and it has obtained the performance without a breaking up of a cone. Moreover, in order to raise special design-shaped a curvy linear cone (an intensity is added to the waveguide plunger under motion) and an intensity, the inverting dust cap by which the new-installation meter was carried out is adopted, and deformation of a cone is small suppressed also under the high power status. In Kappa8.1i, a light weight and quantity rigidity-ization (it is light 10% and harder than before 5%) are attained from the conventional IMG cone. Furthermore, the phi133x19mm magnet and the ribbon wire which demonstrates power to an instant large current are adopted as a magnetic circuit.
The 16cm cone type mid bath unit which used the IMG cone is carried in inside low-pass, and the relation with a Woofer is made smooth.
The 7.6cm poly dome shape unit which adopted the diaphragm which inherited the technology of the first Kappa series is carried in the mid-high range. This diaphragm is a thing of a software polypropylene synthetic of the newly developed super-thin film (0.3mm), and also the diffuser of the aluminum mesh is attached to the dome rear surface. Disorder of the frequency characteristic by a rear surface wave is suppressed without applying an append to a diaphragm by this diffuser, and the flat frequency characteristic and Low-noise-izing are attained. Furthermore, the sound energy emitted to the dome rear surface was led to the back cavity from the center of a magnetic circuit of the special structure, and has eliminated the influence by backplane sound pressure. This poly dome is driving the diaphragm of the shape of a low dome of Q from the dome perimeter with the large-diameter edge volume voice coil.
The planar drive type EMIT-R tweeter which adopted the circular diaphragm is carried in the high region. The planar diaphragm of an EMIT-R tweeter is using the ultra-thin KAPTON film, carries out photo etching of the annular voice coil to the top layer, constitutes a timbal, and is driving the diaphragm directly combining a special-shaped magnetic circuit. This has acquired the flat frequency characteristic and extensive directional characteristics.
A network design performs a real-time fine tune in an anechoic chamber, and finally it is the same room as actual family environment, and it is a computer which uses a MLSSA FET special NetWare program, and the area of each loudspeaker unit of operation is determined, and also it opts [ it repeats many audition experiments and ] for it. Moreover, each component partses, such as a capacitor, a resistor, a coil, are selected carefully by subjectivity audition experiment, and are using the very-thick monster cable of the Infiniti special edition also about internal-wiring material.
By amplifier is supported and inside loud sound is equipped with level adjustment.
The enclosure has adopted the column-like polygon cabinet in order to suppress the influence of an internal stationary wave to a min. The baffle material of 26.5mm thickness, native wood solid oak material, and a board with an oak are stuck. Moreover, the bass-reflex duct is prepared in the lower of an enclosure backplane, and it adjusts for tuning of a bass and the room using the spike which can be removed.
There was also a Black oak model as an ordering model.
Two speakers shipping Not included
Re: Infinity kappa 8.1 Series II Black Oak
Sorry! This ad does not allow guest replies. Please log in, or register to reply to this ad.
Calculate Estimated Shipping Cost
This feature is only available for logged in members. Please login or register here.